Technology Wood

The front of the draw needs a handle. for this i find a piece of scrap wood and cut out a length 95mm across. i copied the angle of the...

as i made a hall table it is made to sit against a wall because of this it will stick out 10mm from the wall because of the skirting. i...

i made buttons to attach to the table top. these buttons are to prevent splitting and qwerks in the timber as it dries or moves. to make...

to make the draw i made a dovetail joint in the front. this is because if it was just a glue join, the constant pulling would mean it...

to add the back i had to router a rebate so that it would it would sit flat. so that the router would run flush a clamped a scrap bit of...

Some of the biscuits which I have prepared for the mitered biscuit joints in the legs which have joined up. To do this I used a skill saw...

Before I glue my work together I put it all together dry so that I can check its square and so it all fits together without any gaps....

All of my work has been drilled with a biscuit joiner ready for the biscuit to join the skeleton of the table. When using this machine I...

Testing the festool and biscuits before I begin on my table project. While using the festool I wore safety glasses to protect from chips...

Clamped work. Testing if its flush before doweling and gluing. I used a square to make sure all corners were 90 degrees so once its glued...

Legs that have been sanded and ready for joining. They were sized using a thicknesser then I measured them to be rough cut on the band...

the rails which have been sanded and ready to join. these were cut on the band saw. the band-saw had the dust extractor on meaning I...